|
|
|
Frequency Range |
100KHz to 2060MHz |
|
Frequency Step |
5KHz to 9995KHz in multiples of 5KHz or 6.25KHz |
|
Ref. Oscillator Accuracy |
±3 PPM |
|
Frequency Marker Accuracy |
±25 PPM |
|
Frequency Measurements |
Narrow Band FM, Wide Band FM, AM and Single side
band |
|
|
|
|
|
Input Impedance |
50W |
|
Maximum Input Volts |
5V RMS (+27dBm) |
|
Measurement Units |
dBmV, dBµV, dBm |
|
Attenuation |
0dB or -10dB internal
0dB to 60dB with external Attenuator |
|
|
|
|
|
Level Measurement Range |
-117dBm to -67dBm (1MHz to 2060MHz) |
|
Resolution |
±0.5dB |
|
Accuracy |
±3dB |
|
Bandwidth |
12.5KHz |
|
|
|
|
|
Level Measurement Range |
-108dBm to -58dBm (10MHz to 2060MHz) |
|
Resolution |
±0.5dB |
|
Accuracy |
±3dB |
|
Bandwidth |
Wide band FM: Approx. 180KHz
AM and SSB: Approx. 2.4KHz |
|
BFO Frequency Range |
±1.5KHz |
|
Reception Sensitivity |
0 to 6dBµV EMF with supplied antenna |
|
Antenna Reception S/N Ratio |
N-FM: 10 dB
W-FM: 12 dB |
|
|
|
|
|
Display Modes |
Spectrum, Bar graph, Frequency counter |
|
Spectrum Display |
Displays 160 channels |
|
Bar Graph Displays |
Multi channel (2, 5, 10, 20, 40, 80, 160 bar
graphs per display), Single Channel and 2 Channel difference |
|
Sweep Modes |
Single, Normal, Free run |
|
Spurious Signals |
(internally generated) -35dBc for W-FM -45dBc for
N-FM (typical below full scale signal level) |
|
|
|
|
|
Mode |
Manual, Channel (memory scan) and Search scan |
|
Scan Rate |
12.5 Ch/sec |
|
|
|
|
|
Data Memory |
Stores 10 displays of up to 160 CH per display |
|
Setup Memory |
Stores 10 setups for each scan mode |
|
|
|
|
|
Bandwidth |
9MHz to 2060MHz |
|
Resolution |
1KHz |
|
Accuracy |
50PPM ±1 count |
|
Input Impedance |
50W |
|
Max. Input Voltage |
5V RMS |
|
Response Time |
0.512 sec |
|
Input Sensitivity |
9MHz to 2060MHz: 120mV
20MHz to 1500MHz: 50mV
2MHz to 2060MHz: 500mV |
|
Data Memory |
Stores 10 Readings |
|
|
|
|
|
LCD |
192 x 192 Pixels, Light green |
|
Back Light |
LED. Back light will shut off 5 seconds after the
last key depression |
|
Interfaces |
Std RS-232 interface with female 8 pin mini Din
connector. Baud Rates of 1200, 2400, 4800 or 9600 BPS are menu
selected. The software supplied is a Windows®-based program,
which runs under Windows 95/98/ME/XP/2000. |
|
Auto Power Off |
5, 10, 20 or 30 minutes after the last key
depression (user selected) |
|
Audio Output |
120mW into 8W Speaker |
|
Power Requirements |
(6) AA NiCd or Alkaline Batteries, 12 volt car
adapter or 11V to 16V 500 mA Max AC to DC adapter |
|
|
|
|
|
Operating Temperature |
0°C to 40°C (32 to 104°F) |
|
Relative Humidity |
35% to 85% |
|
Storage Temperature |
-10 to 50°C (14 to 122°F) |
|
Size |
9.5" (H) x 4.0" (W) x 1.8" (D) |
|
Weight |
1.4 lbs |
|
Supplied Accessories |
Manual, (6) 1.5V AA NiCd Batteries, Detachable 9"
whip antenna, RS-232 Cable and Software, Carrying case,
Earphone, Carrying strap, Vehicle power adapter, AC/DC adapter |
|
|
|
Frequency Range |
100kHz to 2900MHz |
|
Frequency Step |
5kHz to 9995kHz in multiples of 5kHz or 6.25kHz |
|
Ref. Oscillator Accuracy |
±3 PPM |
|
Frequency Marker Accuracy |
±25
PPM |
|
Frequency Measurements |
Narrow Band FM, Wide Band FM, AM and Single side band |
|
|
|
|
|
Input Impedance |
50W |
|
Maximum Input Volts |
5V RMS (+27dBm) |
|
Measurement Units |
dBmV, dBµV, dBm |
|
Attenuation |
0dB or -10dB
internal; 0dB to 60dB with external Attenuator |
|
|
|
|
|
Level Measurement Range |
-117dBm to -67dBm (300MHz to 1800MHz)
-107dBm to -67dBm (1MHz to 300MHz and 1800MHz to 2900MHz) |
|
Resolution |
±0.5dB;
Accuracy: ±3dB |
|
Bandwidth |
12.5kHz |
|
|
|
|
|
Level Measurement Range |
-107dBm to -57dBm (300MHz to 1800MHz)
-97dBm to -57dBm (10MHz to 300MHz and 1800MHz to 2900MHz) |
|
Resolution |
±0.5dB |
|
Accuracy |
±3dB |
|
Bandwidth |
Wide band FM:
Approx. 180kHz
AM and SSB: Approx. 2.4kHz |
|
BFO Frequency Range |
±1.5kHz |
|
Reception Sensitivity |
0 to 6dBµV EMF
with supplied antenna |
|
Antenna Reception S/N Ratio |
N-FM: 10 dB; W-FM: 12 dB |
|
|
|
|
|
Display Modes |
Spectrum, Bar graph, Frequency counter |
|
Spectrum Display |
Displays 160
channels |
|
Bar Graph Displays |
Multi channel (2, 5, 10, 20, 40, 80, 160 bar graphs
per display), Single Channel and 2 Channel difference |
|
Sweep Modes |
Single, Normal,
Free run |
|
Spurious Signals |
(internally generated) -35dBc for W-FM
-45dBc for N-FM (typical below full scale signal level) |
|
|
|
|
|
Mode |
Manual, Channel (memory scan) and Search scan |
|
Rate |
125 Ch/s |
|
|
|
|
|
Data Memory |
Stores 10 displays of up to 160 CH per display |
|
Setup Memory |
Stores 10
setups for each scan mode |
|
|
|
|
|
Bandwidth |
9MHz to 2900MHz |
|
Resolution |
1kHz |
|
Accuracy |
50PPM ±1 count |
|
Input Impedance |
50W |
|
Max Input Volts |
5V RMS |
|
Response Time |
0.512 Sec. |
|
Input Sensitivity |
9MHz to 2060MHz: 120mV
20MHz to 1500MHz: 50mV
2MHz to 2800MHz: 500mV
2800MHz to 2900MHz: 750mV |
|
Data Memory |
Stores 10
Readings |
|
|
|
|
|
LCD |
192 x 192 Pixels, Light green |
|
Back Light |
LED. Back light
will shut off 5 seconds after the last key depression |
|
Interfaces |
Std RS-232 interface with female 8 pin mini Din
connector. Baud Rates of 1200, 2400, 4800 or 9600 BPS are menu
selected. The software supplied is a Windows(r)-based program, which
runs under Windows 95/98/ME/XP/2000. |
|
Auto Power Off |
5, 10, 20 or 30
minutes after the last key depression-user selected. |
|
Audio Output |
120mW into a 8W Speaker |
|
Power Requirements |
(6) AA NiCd or
Alkaline Batteries, 12 volt car adapter or 11V to 16V 500 mA Max AC
to DC adapter |
|
|
|
|
|
Operating Temperature |
0°C to 40°C |
|
Relative Humidity |
35% to 85% |
|
Storage Temperature |
-10 to 50°C |
|
Size |
9.5" H x 4.0" W
x 1.8" D |
|
Weight |
1.4 lb |
|
Supplied Accessories |
Manual, (6)
1.5V AA NiCd Batteries, Detachable 9" whip antenna, RS-232 Cable,
Carrying case, Earphone, Carrying strap and Software, Vehicle power
adapter, AC/DC converter. |
|
|
