271 DDS Function Generator with ARB 

High performance function generator

High stability 10 MHz DDS function generator Arbitrary capability with storage for five user defined waveforms Multiple standard and complex waveforms recalled from internal memory Extensive modulation capabilities include sweep, AM, Gating, Trigger/Burst, FSK and Hop GPIB and RS-232 interfaces

A wide range of waveforms
The Fluke 271 generates high quality sine, square and pulse waveforms over the full frequency range of 0.1 mHz to 10 MHz.
Triangle waveforms, ramp waveforms and multi-level square waves can also be generated, subject to some limitations in the maximum useable frequencies.
Variable symmetry/duty-cycle is available for all waveforms.

Arbitrary waveform capability
Arbitrary waveforms can be loaded via the digital interfaces and then used in a similar way to the standard waveforms.

Up to five arbitrary waveforms of 1024 10-bit words can be stored in non-volatile memory. The waveform clock is 27.48 MHz maximum.
This facility considerably expands the versatility of the 271, making it suitable for the generation of highly complex waveform patterns.

In addition, the 271 offers numerous “complex” waveforms pre-defined in ROM.
These include commonly used wave shapes such as sine x/x, decaying sinewave, and exponential rise and fall.

Powerful modulation modes
Sweep. All waveforms can be swept over their full frequency range at a rate variable between 10 milliseconds and 15 minutes.
The sweep is fully phase continuous. Sweep can be linear or logarithmic, single or continuous.
Single sweeps can be triggered from the front panel, the trigger input, or the digital interfaces.

Two sweep markers are provided, which are adjustable while sweep is running.
The markers can provide a visual indication of frequency points on an oscilloscope or chart recorder.

AM. Amplitude modulation is available for all waveforms and is variable in 1 % steps, up to 100 %.

FSK. Frequency shift keying provides phase coherent switching between two selected frequencies at a rate defined by the switching signal source.
The rate can be set from dc to 50 kHz internally, or dc to 1 MHz externally.

Trigger/Burst. All waveforms are available as a triggered burst, whereby each positive edge of the trigger signal will produce one burst of the carrier,
starting and stopping at the phase angle specified by the start-stop phase setting. The number of cycles in the burst can be set between 0.5 and 1023.

Gated. The gated mode turns the output signal on when the gating signal is high and off when it is low.
Both triggered and gated modes can be operated from the internal trigger generator (0.005 Hz to 50 kHz) or from an external source (dc to 1 MHz).

Waveform hop. The generator can be set up to ‘hop’ between a number of different waveform setups, either at a pre-determined rate or in response to a manual or bus trigger.
Up to 16 different hop waveforms can be defined in terms of frequency, amplitude, function, offset and duration, which is variable in 1 ms steps up to 60 seconds.

Noise generation. The Fluke 271 can be set to simulate wide band random noise with adjustable amplitude and offset.

Locked generators
The signals from the Clock In/Out socket and the Sync Out socket can be used to phase lock two or more generators.
This feature can be used to generate multi-phase waveforms or locked waveforms of different frequencies